LUX 32-bit Quadcopter Flight Controller FC-LUX

Product Code
FC-LUX
Special Price £15.90 £13.25 Regular Price £31.80
  • PayPal
  • Klarna.
  • Braintree
  • Secure Payment Methods

The Lux FC is perfect for beginners and serious quad racers alike. It's suited to beginners as the connections and setup is very straightforward. Unlike most other FCs, with the LUX you don't need to use a separate PDB (power distribution board) as the LUX has its own built in; you can connect both your ESCs and battery connection to it directly (support 6-24v).

The keen racers out there will appreciate its fast F3 processors and sensitive gyro with refresh rates of up to 8kHz. The board has four motor connections, 3 UART connections and multiple connections for peripheral devices including a buzzer, current sensor, LED and RSSI input.

The LUX supports PPM or Serial RX (including Futaba, FrSky, S.BUS).

The LUX comes with CleanFlight pre-installed and has been designed to give a flight performance second to none in a low profile, stackable, race ready package.

Note: PWM input for individual channels is not supported.

Features:

  • High Speed SPI 8kHz Gyro.
  • MPU interrupt connected to F3, allowing the F3 to know immediately when fresh data is available.
  • Dedicated Boot button for easy firmware flashing.
  • Reinforced solder pads for trouble-free direct soldering.
  • Ultra-low profile design.
  • Recessed, sideways pin headers. Also enables soldering of all wires directly to pads without use of any pin headers.
  • Supports PPM or Serial RX (including Futaba, FrSky, S.BUS). A signal inverter is already included for S.BUS.
  • Input voltage 6v to 24v. Power the board directly from flight pack up to 6S ('BAT' pad only!).
  • VIN + VBAT merged - A single wire to power the board will provide voltage input and Telemetry/OSD voltage data.
  • Filtered voltage output - output 5v 1A (and 3.3v where applicable) to power peripherals such as GPS, RX, BLACKBOX, OSD.
  • Selectable receiver voltage 3.3/5V.
  • USB Conflict resolution - Hardware inversion, SBUS or telemetry can be used on any of the 3 available hardware serial ports. USB will not interfere with peripherals.
  • Cleanflight support (RACE target).
  • BLHeli flashing supported by hardware.
  • RacEfliteight ready / Betaflight ready (BasEfliteight firmware not supported)
  • Micro USB connector for programming.
More Information
Product CodeFC-LUX
Bundle AvaliableNo
LiPoNo
Pre OrderNo
DiscontinuedNo
EAN / Barcode9900001181405
BrandAlignTrex
Weight0.210000
0
Rating:
0% of 100
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account
Customer Questions
No Questions
Please, mind that only logged in users can submit questions